Operation Manual

Dahua Network Camera Web 3.0 Operation Manual
105
Parameter
Function
Relay out
Enable alarm activation function. You need to select alarm output port so
that system can activate corresponding alarm device when alarm occurs.
Alarm Delay
System can delay the alarm output for specified time after alarm ended.
Send Email
If you enabled this function, System can send out email to alert you when
alarm occurs and ends. User can set email address in Network>SMTP.
Snapshot
Select “Snapshot” and the system will auto trigger alarm and snapshot when
alarm occurs.
Step 5
Click “Save” to complete the setup of face detection.
5.3.6 People Counting
5.3.6.1 People Counting
Step 1
Select “Setup > Event > People Counting > People Counting” and the system will display the interface
of “Entrance/Exit”, which is shown in Figure 5-75.
Figure 5-75
Step 2
Select “Enable” to enable statistics function of entrance and exit.
Step 3