Spec Sheet

Human temperature measurement blackbody
- 4 -
4. Steps
4.1. Connect
Connect one end of the power cord configured by the factory to
the power outlet on the back of the blackbody and the other end to
the three-hole 220VAC/10A power outlet.
4.2. Temperature setting
a. Turn on the power switch on the back of the blackbody and the red
indicator light is on.
b. See "3.Parameters" for the preset factory temperature of the
boldface. The operation can start when PV value is stable and
consistent with SV value.
c. Blackbody operating temperature can be adjusted according to
the need of the field. Press the "SEL" button (see figure 2), the "SV"
indicator, press " " or " " button to increase or decrease the working
temperature, and then press "SEL" to confirm. (See the table for the
parameters of the control panel: temperature control instrument
panel instructions.)
d. At the end of the work, turn off the power switch on the back of the
blackbody.