Spec Sheet

ManualsBrandsDahua ManualsSecurity CamerasBody Temperature Camera

Human temperature measurement blackbody

- 1 -

Safety Instructions

Warning

A warning indicates a situation that may cause harm to the user. To

avoid personal injury or instrument damage, please follow the

following instructions:

Make sure the place is free of oil and chemicals, no inflammable

and explosive articles!

Working environment is 0 ~ 40 , do not put into high and low

temperature box without permission, to avoid accidents!

Must use an earthing socket in case of accidental electric shock!

Blackbody cannot be used for applications other than

temperature testing and calibration!

Do not change the blackbody range without permission, in case

of damage to the blackbody or cause safety accidents!

Do not remove or modify blackbody without permission! The

product is not guaranteed if the label is torn or damaged.

Caution

To avoid damaging the instrument or affecting the measurement

accuracy, please follow the following instructions:

Do not touch the radiant surface of blackbody to avoid scratches

on the radiant surface of blackbody and affect the temperature

measurement accuracy.

Indoor use only. There should be no obvious air convection and

strong light irradiation, no strong electromagnetic interference

Summary of content (7 pages)

PAGE 1
Human temperature measurement blackbody Safety Instructions Warning A warning indicates a situation that may cause harm to the user.
PAGE 2
Human temperature measurement blackbody and vibration. It is necessary to reserve heat dissipation space and keep at least 10cm away from surrounding objects. Safety life: the safety of blackbody can not be guaranteed after five years from the date of purchase (no matter whether the product is used within five years or not). Beyond this service life, the components may appear aging and failure.
PAGE 3
Human temperature measurement blackbody Temperature control instrument Red and green signal lights and WIFI antenna jack are only applicable to HBB2 series models Fan Black body radiant surface Power socket Power switch Power must be grounded! Figure 1: Product picture 3. Parameters Working temperature Effective radiant surface Temperature resolution Environment temperature +5.0 adjustable 70mm×70mm 0.1 Temperature accuracy ±0.2 Temperature stability ±( 0.1 0.2 ) /30min 0.
PAGE 4
Human temperature measurement blackbody 4. Steps 4.1. Connect Connect one end of the power cord configured by the factory to the power outlet on the back of the blackbody and the other end to the three-hole 220VAC/10A power outlet. 4.2. Temperature setting a. Turn on the power switch on the back of the blackbody and the red indicator light is on. b. See "3.Parameters" for the preset factory temperature of the boldface. The operation can start when PV value is stable and consistent with SV value. c.
PAGE 5
Human temperature measurement blackbody Figure 2: schematic diagram of temperature control instrument panel Temperature control instrument panel instructions Parameter C1 C2 Name Function Control output 1 indicator light Control output 2 indicator light This light is ON when control output 1 is ON This light is ON when control output 2 is ON When the alarm output 1 is ON, the light will be ON When the alarm output 2 is ON, the light will be ON Indicates the target temperature Used to select and set th
PAGE 6
Human temperature measurement blackbody 1 No display on startup 2 Display UUUU fuse to factory for maintenance temperature Sensor break - return to factory for maintenance 3 Display LLLL 4 Display FRL7 return to factory for maintenance 5 Fan does not work factory for repair 6 After setting SV value, PV value does not respond.
PAGE 7
Human temperature measurement blackbody b. When not in use, put the equipment into the packaging box, and ensure the storage environment temperature and humidity appropriate. c. It is recommended to use a neutral cleaner to clean the blackbody shell and a soft brush to clean the dust on the radiant surface of the blackbody. The appearance and dimension of the product shall be subject to the actual delivery.