User's Manual

Parameter
Description
Flip
Select the camera installation option:
Inclined: camera is installed above the monitoring area.
Vertical: camera is installed at an angle or on the side of the monitoring
area.
Regional
Number
Statistic AI
Click the checkbox to set a threshold value for the number of people in
the monitoring area. Leave this checkbox blank to just keep a count of the
number of people in an area.
Inside Number: The threshold value for the number of people in the
area. Type a number between 0 and 30 (default: 30)
Type: Select a threshold function:
≥ Threshold: the function triggers an alarm if the number of people within
the area is greater than or equal to the Threshold value.
≤ Threshold
: the funcation triggers an alarm if the number of people
within the area is less than or equal to the Threshold value.
Stranding
Alarm
Click the check box to enable the function to trigger an alarm if an
individual target inside the monitoring area must remain in the defined
area before the function triggers the alarm. Set the time between 1
second and 1800 seconds (default: 30 seconds).
Record
Select Record to send video data to the camera’s onboard storage when
a tripwire alarm is triggered. Then, set a record delay period, in seconds.
The camera must have an on-board storage mechanism, specifically a
MicroSD card slot with a MicroSD card installed.
Relay Out
Select Relay-out to send an alarm transmission signal from the camera
to an alarm relay. Then, set an Alarm Delay period, in seconds. The
camera must have an active alarm relay connection.
Send Email
Select Send Email to issue an email when an alarm is triggered. Set
email addresses in the Network -> SMTP (email) setting box.
Snapshot
Select Snapshot to record a snapshot of the scene that shows the tripwire
violation.
Click Save to accept the parameters and to activate the trigger.
Click Default to erase all rules and to start with a clean scene cameo window.