User's Manual

Set the functional parameters using the table below:
Parameter
Description
Inside
Number
Click the check box to display the number of people inside the monitoring area
on the camera’s live view.
Period
Configure working period, and the rule takes effect only within this period.
1. Click Setting to open the Period setting window.
2. Configure each period.
A: Press and hold the left mouse button, and then drag at the periods you need.
B: Click the Setting behind the week day you need, and then the week day in
the period setting box shows red color, select and configure the periods
you need, and you can configure 6 periods in one week day at most.
3. Click OK.
Sensitivity
Set the sensitivity level for the number of people in the monitoring area.
Set the sensitivity between 1 and 10 (default: 7).
Flip
Select the camera installation option:
Inclined: camera is installed above the monitoring area.
Vertical: camera is installed at an angle or on the side of the monitoring area.
Regional
Number
Statistic AI
Click the checkbox to set a threshold value for the number of people in the
monitoring area. Leave this checkbox blank to keep only a count of the
number of people in an area.
Inside Number: The threshold value for the number of people in the area.
Type a number between 0 and 30 (default: 30)
Type: Select a threshold function:
≥ Threshold: the function triggers an alarm if the number of people within the
area is greater than or equal to the Threshold value.
≤ Threshold: the funcation triggers an alarm if the number of people within the
area is less than or equal to the Threshold value.
Stranding
Alarm
Click the check box to enable the function to trigger an alarm if an individual
target inside the monitoring area must remain in the defined area before the
function triggers the alarm.
Set the time between 1 second and 1800 seconds (default: 30 seconds).
Record
Select Record to send video data to the camera’s onboard storage when a
tripwire alarm is triggered. Then, set a record delay period, in seconds.
The camera must have an on-board storage mechanism, specifically a
MicroSD card slot with a MicroSD card installed.
Relay Out
Select Relay-out to send an alarm transmission signal from the camera to an
alarm relay. Then, set an Alarm Delay period, in seconds.
Send Email
Select Send Email to issue an email when an alarm is triggered. Set email
addresses in the Network -> SMTP (email) setting box.
Snapshot
Select Snapshot to record a snapshot of the scene that shows the tripwire
violation.
Click Save to accept the parameters and to activate the trigger.
Click Default to erase all rules and to start with a clean scene cameo window.