User's Manual

Parameter
Description
Action
Set the intrusion action: Appear or Cross.
Appear: Triggers an alarm once a target appears in the defined area.
Cross: Triggers an alarm once a target enters or exits the defined area.
Set the Direction for the Cross action:
Enter: Triggers an alarm once a target enters the intrusion area.
Exit: Triggers an alarm once a target exits the intrusion area.
Enter&Exit: Target must enter and exit the intrusion area to trigger and
alarm.
Object Filter
Select the Object Filter check box to enable the function, and then select
the alarm object.
Select Human or Motor Vehicle (both options can be used at the same
time) to set the alarm trigger to a particular target.
If you disable this function, any moving object (such as human, vehicle, cat,
or dog) triggers an alarm.
This function is only available on devices with perimeter protection
function.
Record
Select Record to send video data to the camera’s onboard storage when a
tripwire alarm is triggered. Then, set a record delay period, in seconds.
The camera must have an on-board storage mechanism, specifically a
MicroSD card slot with a MicroSD card installed.
Relay Out
Select Relay-out to send an alarm transmission signal from the camera to
an alarm relay. Then, set an Alarm Delay period, in seconds.
The camera must have an active alarm relay connection.
Send Email
Select Send Email to issue an email when an alarm is triggered. Set email
addresses in the Network -> SMTP (email) setting box.
Snapshot
Select Snapshot to record a snapshot of the scene that shows the tripwire
violation.