Owner's manual

51
Figure 4-39
4.9.6 Activate Pattern Function
In X346H346H346H350HFigure 4-36X, input mode value in the No. blank, and click pattern button.
4.9.7 Auto Scan Setup
In X347H347H347H351HFigure 4-35X, click border button. The interface is shown as in X348H348H348H352HFigure 4-30X.
Please go to
X349H349H349H353HFigure 4-32X, use direction arrows to select camera left limit
Then please go to
X350H350H350H354HFigure 4-40X and click left limit button
Repeat the above procedures to set right limit.
Figure 4-40
4.9.8 Activate Auto Scan
In X351H351H351H355HFigure 4-36X, click “Auto Scan” button, the system begins auto scan. Correspondingly, the auto
scan button becomes Stop button. Click stop button to terminate scan operation.
4.10 Flip
In X352H352H352H356HFigure 4-36X, click page switch button, you can see an interface is shown as below. See X353H353H353H357HFigure
4-41
X. Here you can set auxiliary function. The aux value has relation ship with the Aux button of
the decoder.
Click page switch button again, system goes back to
X354H354H354H358HFigure 4-32X.
Figure 4-41