User's Manual
Table Of Contents
- Cybersecurity Recommendations
- Regulatory Information
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Camera
- 3.2.2 Dome Camera
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
Setting 77
SMTP (Email) Figure 4-29
Configure your SMTP server. Step 2
For SMTP (Email)’s other parameters to be configured, see Table 4-16. Step 3
Table 4-16 SMTP (Email) parameter description
Parameters
Description
Anonymity
Enable Anonymity, and senders’ identities will not be displayed in Emails
transmitted to others.
Sender
Sender’s email address
Encryption type
Select Authentication type from None, SSL and TLS. TLS is set by default.
Attachment
Select the check box to support attachment in the email.
Title
You can enter no more than 63 characters in Chinese, English, and Arabic
numerals.
Receiver
Receiver’s mail address. Supports 3 addresses at most.
Interval
Time intervals of sending alarm Emails. "0" means there is no interval. Set a
time interval (normally >0s) as you want and when alarm, video detection,
or event is triggered, Emails will not be transmitted all the time but be
transmitted in the time interval you have set. This function is aimed at
easing the pressure that is put on the Email server when there are quite a
lot of abnormal events.
Health Mail
The system sends test mail to check if the connection is successfully set up.
Select Health Mail to configure Update Period. E-mail testing results will
be transmitted in time intervals you have set.
Test
Test the email sending and receiving function. If the configuration is correct,
you would receive test email. Save email configuration before running rest.
Click Save to finish configuration. Step 4