User's Manual
Table Of Contents
- Cybersecurity Recommendations
- Regulatory Information
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Camera
- 3.2.2 Dome Camera
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
Daily Operation 44
Click the Report tab. Step 1
The Report interface is displayed. See Figure 3-40.
Report
Figure 3-40
Set the conditions for searching and click Search. Step 2
Temperature data you have searched is displayed. See Figure 3-41.
Result of report searching Figure 3-41
Alarm 3.5
You can select alarm type as needed, when the selected alarms are triggered, the system
would record detailed alarm information at the right side of the interface.
Function of different devices might vary, and the actual product shall prevail.
3.5.1 Introduction to Alarm Types
For alarm types and conditions that trigger an alarm, see Table 3-14.
Table 3-14 Alarm type description
Alarm Type
Description
Condition
Motion
detection
The alarm is triggered
when moving objects
are detected.
You have enabled motion detection. For
detailed operations, see "4.5.1 Configuring
Video Detection."
Disk full
The alarm is triggered
when the free space in
the SD card is lower
than the set percentage.
You have enabled detection to lack of SD card
storage space. For detailed operations, see
"4.5.5.1 Configuring SD Card Abnormality
Parameters."