User's Manual
Table Of Contents
- Cybersecurity Recommendations
- Regulatory Information
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Camera
- 3.2.2 Dome Camera
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
Setting 135
Date & Time Figure 4-84
Configure Date & Time parameters. See Table 4-46 for details. Step 2
Table 4-46 Date & Time parameters
Parameter
Description
Date Format
Date format.
Time Format
Configure the Time format, you can select from 24-Hour or 12-Hour.
Time zone
Configure the Time zone that the device is at.
Current Time
Configure system time.
Click "Sync PC", and the system time changes to the time on PC.
DST
Enable DST as needed.
Select the check box to enable daylight saving time. Select "DST", and
then configure start time and end time of DST with dates or days of the
week.
NTP
When you need the Device to transmit its time to NTP server, you can
select the NTP check box to enable it.
Server
IP address or domain name of the NTP server.
Port
Port number of the FTP server.
Interval
Time gap of device’s transmission of its current time to NTP server.
Click Save to finish configuration. Step 3
4.8.1.3 Configuring GPS
Fill in the camera’s GPS information in the web to remind you where your camera locates.
Also, automatically sent to the management platform, the GPS information can be viewed on
the platform to help the platform operator track your camera.
This function is supported on select models and the actual interface shall prevail.
Select Setting > System > General > GPS.
Step 1