User's Manual
Table Of Contents
- Cybersecurity Recommendations
- Regulatory Information
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Camera
- 3.2.2 Dome Camera
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
Setting 117
The "No SD Card", "SD Card Error" and "Capacity Warning" events are available only on
models that support SD card.
4.5.5.1 Configuring SD Card Abnormality Parameters
When any abnormality happens to the SD card, an alarm will be triggered and linked activities
will be executed. SD card abnormality includes "No SD card", "SD Card Error" and "Capacity
Warning."
Select Setting > Event > Abnormality > SD Card. Step 1
The SD Card interface is displayed. See Figure 4-60.
SD card Figure 4-60
Select an event type.
Step 2
Select the Enable check box. Step 3
Configure SD card abnormality parameters. For detailed description, see Table 4-34. Step 4
Table 4-34 SD card parameter description
Parameters
Description
Minimum storage
space in SD card
This parameter can be configured only when the event type is
"capacity warning."
Configure the free space percentage, and if the free space in the SD
card is lower than the set percentage, the alarm is triggered.
Relay-out
You can connect this relay-out port to alarm devices such as light
and siren. When an alarm is triggered, those alarm devices will work.
Select the check box to enable this function.
Alarm Delay
Set a length of time for the Device to delay turning off alarm after an
event is actually ended.
Send Email
Select the Send Email check box and an e-mail will be delivered to
the device user once an alarm is triggered.
Set your e-mail first before enabling the Send Email function. See
"4.2.5 Configuring SMTP" for detailed operations.
Click Save to finish configuration. Step 5