User's Manual
Table Of Contents
- Cybersecurity Recommendations
- Regulatory Information
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Camera
- 3.2.2 Dome Camera
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
Setting 132
FTP settings Figure 4-80
Select the Enable check box, and then select the service type. Step 2
SFTP service is recommended.
Configure FTP parameters. See Table 4-42. Step 3
Table 4-42 FTP parameter description
Parameters
Description
Server Address
The IP address of the SFTP or FTP server.
Port
The port of the SFTP or FTP server.
User name
The user name to log in the server.
Password
The password to log in the server.
Remote Directory
The destination path in the server.
Emergency (Local)
Select the Emergency (Local) check box, and when the FTP
server does not work, all the files are saved to the internal SD card.
Click Save to finish configuration. Step 4
Click Test to check whether the server has been properly connected.
4.7.2.4 Configuring NAS Server
This function can be enabled only when NAS has been selected as destination path. Select
NAS interface and you can save files in NAS server.
Select Setting > Storage > Destination > NAS. Step 1
The NAS interface is displayed. See Figure 4-81.
NAS settings Figure 4-81