User's Manual
Table Of Contents
- Cybersecurity Recommendations
- Regulatory Information
- Foreword
- 1 Product Introduction
- 2 Basic Settings
- 3 Daily Operation
- 3.1 Live
- 3.2 PTZ
- 3.2.1 Bullet Camera
- 3.2.2 Dome Camera
- 3.2.2.1 Configuring Protocol
- 3.2.2.2 Configuring PTZ Functions
- 3.2.2.2.1 Configuring Preset
- 3.2.2.2.2 Configuring Tour
- 3.2.2.2.3 Configuring Scan
- 3.2.2.2.4 Configuring Pattern
- 3.2.2.2.5 Configuring Pan
- 3.2.2.2.6 Configuring PTZ Speed
- 3.2.2.2.7 Configuring Idle Motion
- 3.2.2.2.8 Configuring Power Up
- 3.2.2.2.9 Configuring Time Task
- 3.2.2.2.10 Restarting PTZ Manually
- 3.2.2.2.11 Restoring PTZ to the Default Settings
- 3.2.2.3 Operating PTZ
- 3.2.2.4 Configuring Preset Backup
- 3.3 Playback
- 3.4 Reports
- 3.5 Alarm
- 4 Setting
- 4.1 Configuring Camera
- 4.1.1 Configuring Lens
- 4.1.2 Configuring Video Parameters
- 4.1.3 Configuring Audio Parameters
- 4.2 Configuring Network
- 4.3 Peripheral
- 4.4 Smart Thermal
- 4.5 Event
- 4.6 Temperature Measuring Settings
- 4.7 Storage Management
- 4.8 System Management
- 4.1 Configuring Camera
- 5 System Maintenance
- 6 Additional Accessing Methods
Setting 127
Color code Figure 4-71
4.6.3 Exporting Heat Map
By exporting heat map, you can grasp temperature of every pixel on thermal images.
Select Setting > Temperature > Heat Map. Step 1
The Heat Map interface is displayed. See Figure 4-72.
Heat map setting Figure 4-72
Click Export Heat Map. Step 2
Heat map files will be saved under the path you have set. For detailed operation of
resetting the storage path, see "4.1.2.5 Configuring Storage Path."
Storage Management 4.7
4.7.1 Configuring Schedule
You can set schedule of recording, snapshotting, holidays.
If the record mode is Off in Storage > Record Control > Record Control interface, the system
would not record video or snapshot as scheduled.
4.7.1.1 Configuring Video Recording
Set video recording, covering General, Motion and Alarm.