User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Configuration Flow
- 3 Device Initialization
- 4 Login
- 5 Main Interface
- 6 Setting
- 6.1 Local
- 6.2 Camera
- 6.2.1 Setting Image Parameters
- 6.2.2 Setting Encode Parameters
- 6.2.2.1 Encode
- 6.2.2.2 Overlay
- 6.2.2.2.1 Configuring Privacy Masking
- 6.2.2.2.2 Configuring Channel Title
- 6.2.2.2.3 Configuring Time Title
- 6.2.2.2.4 Configuring Location
- 6.2.2.2.5 Configuring Font Properties
- 6.2.2.2.6 Configuring Picture Overlay
- 6.2.2.2.7 Configuring Custom Title
- 6.2.2.2.8 Configuring Target Statistics
- 6.2.2.2.9 Configuring Face Detection
- 6.2.2.2.10 Configuring Face Recognition
- 6.2.2.2.11 Configuring Face Statistics
- 6.2.2.3 ROI
- 6.2.3 Setting Audio Parameters
- 6.3 Network
- 6.4 Event
- 6.5 Storage
- 6.6 System
- 6.7 System Information
- 6.8 Setting Log
- 7 Live
- 8 AI
- 9 Camera
- 10 Event
- 11 System
- 12 Security
- 13 Record
- 14 Picture
- 15 Report
- Appendix 1 Cybersecurity Recommendations
Operation Manual
43
Figure 6-31 UPnP
Step 2 Click next to
Enable
, and there are two mapping modes:
Custom
and
Default
.
● Select
Custom
, click and then you can change external port as needed.
● Select
Default
, and then the system finishes mapping with unoccupied port
automatically, and you cannot edit mapping relation.
Step 3 Click
Apply
.
Open web browser on PC, enter http:// wide area IP address: external port number,
and then you can visit the local area device with corresponding port.
6.3.7 SNMP
SNMP (Simple Network Management Protocol), which can be used to enable software such as
MIB Builder and MG-SOFT MIB Browser to connect to the camera and manage and monitor
the camera.
Prerequisites
● Install SNMP monitoring and managing tools such as MIB Builder and MG-SOFT MIB
Browser.
● Get the MIB file of the matched version from technical support.
Procedure
Step 1 Select >
Network
>
SNMP
.