User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Configuration Flow
- 3 Device Initialization
- 4 Login
- 5 Main Interface
- 6 Setting
- 6.1 Local
- 6.2 Camera
- 6.2.1 Setting Image Parameters
- 6.2.2 Setting Encode Parameters
- 6.2.2.1 Encode
- 6.2.2.2 Overlay
- 6.2.2.2.1 Configuring Privacy Masking
- 6.2.2.2.2 Configuring Channel Title
- 6.2.2.2.3 Configuring Time Title
- 6.2.2.2.4 Configuring Location
- 6.2.2.2.5 Configuring Font Properties
- 6.2.2.2.6 Configuring Picture Overlay
- 6.2.2.2.7 Configuring Custom Title
- 6.2.2.2.8 Configuring Target Statistics
- 6.2.2.2.9 Configuring Face Detection
- 6.2.2.2.10 Configuring Face Recognition
- 6.2.2.2.11 Configuring Face Statistics
- 6.2.2.3 ROI
- 6.2.3 Setting Audio Parameters
- 6.3 Network
- 6.4 Event
- 6.5 Storage
- 6.6 System
- 6.7 System Information
- 6.8 Setting Log
- 7 Live
- 8 AI
- 9 Camera
- 10 Event
- 11 System
- 12 Security
- 13 Record
- 14 Picture
- 15 Report
- Appendix 1 Cybersecurity Recommendations
Operation Manual
38
The configuration of
Max Connection
takes effect immediately, and others will take
effect after reboot.
6.3.3 PPPoE
Point-to-Point Protocol over Ethernet, is one of the protocols that device uses to connect to the
internet. Get the PPPoE username and password from the internet service provider, and then
set up network connection through PPPoE, the camera will acquire a WAN dynamic IP
address.
Prerequisites
● The camera has connected to the network.
● You have gotten the account and password from Internet Service Provider.
Procedure
Step 1 Select >
Network
>
PPPoE
.
Figure 6-28 PPPoE
Step 2 Click , and then enter username and password.
● Disable UPnP while using PPPoE to avoid possible influence.
● After making PPPoE connection, the device IP address cannot be modified
through web interface
Step 3 Click
Apply
.
The success prompt box is displayed, and then the real-time WAN IP address is
displayed. You can visit camera through the IP address.
6.3.4 DDNS
Properly configure DDNS, and then the domain name on the DNS server matches your IP
address and the matching relation refreshes in real time. You can always visit the camera with
the same domain name no matter how the IP address changes.
Prerequisites
Check the type of DNS server supported by the camera.
Step 1 Select >
Network
>
DDNS
.