User's Manual

Operation Manual
116
Figure 12-2 Security Status
12.2 System Service
12.2.1 802.1x
Cameras can connect to LAN after passing 802.1x authentication.
Step 1 Select
Security
>
System Service
>
802.1x
.
Step 2 Select the NIC name as needed, and click to enable it.
Step 3 Select the authentication mode, and then configure parameters.
● PEAP: Protected EAP protocol.
1. Select PEAP as the authentication mode.
2. Enter the username and password that has been authenticated on the server.
3. Click next to CA certificate, and select the trusted CA certificate in list.
If there is no certificate in the list, click
Certificate Management
at the left
navigation bar. For details, see "12.4.2 Installing Trusted CA Certificate".
Figure 12-3 802.1x (PEAP)
● TLS: Transport Layer Security. It is applied in two communication application
programs to guarantee the security and integrity of the data.
1. Select TLS as the authentication mode.
2. Enter the username.
3. Click next to CA certificate, and select the trusted CA certificate in list.