User's Manual
Table Of Contents
- Foreword
- Important Safeguards and Warnings
- 1 Overview
- 2 Configuration Flow
- 3 Device Initialization
- 4 Login
- 5 Main Interface
- 6 Setting
- 6.1 Local
- 6.2 Camera
- 6.2.1 Setting Image Parameters
- 6.2.2 Setting Encode Parameters
- 6.2.2.1 Encode
- 6.2.2.2 Overlay
- 6.2.2.2.1 Configuring Privacy Masking
- 6.2.2.2.2 Configuring Channel Title
- 6.2.2.2.3 Configuring Time Title
- 6.2.2.2.4 Configuring Location
- 6.2.2.2.5 Configuring Font Properties
- 6.2.2.2.6 Configuring Picture Overlay
- 6.2.2.2.7 Configuring Custom Title
- 6.2.2.2.8 Configuring Target Statistics
- 6.2.2.2.9 Configuring Face Detection
- 6.2.2.2.10 Configuring Face Recognition
- 6.2.2.2.11 Configuring Face Statistics
- 6.2.2.3 ROI
- 6.2.3 Setting Audio Parameters
- 6.3 Network
- 6.4 Event
- 6.5 Storage
- 6.6 System
- 6.7 System Information
- 6.8 Setting Log
- 7 Live
- 8 AI
- 9 Camera
- 10 Event
- 11 System
- 12 Security
- 13 Record
- 14 Picture
- 15 Report
- Appendix 1 Cybersecurity Recommendations
Operation Manual
109
Procedure
Step 1 Select
AI
>
Smart Plan
Step 2 Click next to
Video Metadata
, and then click
Next
.
Step 3 Click the
Rule Config
tab.
Step 4 Click
Add Rule
to select rules.
The added rules will be display in the list. Click the text box under
Name
to edit the
rule name. The rule is enabled by default.
Figure 8-21 Rule Configure (Video Metadata)
Step 5 Configure
Picture
.
1) Click .
2) Set overlay of motor vehicle, non-motor vehicle and people and the box position.
This section takes the configuration of non-motor vehicle overlay as an example.
Figure 8-22 Picture (non-motor vehicle)
3) Click
Apply
.
Step 6 (Optional) Click the icons at the right side of the image to filter targets in the image.
● After the rule is enabled, the detection area is displayed. Click , and you drag
the any corner of the box to adjust the size of the area, and press the left mouse
button and move the box to adjust the position.
● Click to draw an area exclusion area for face detection in the image, and
right-click to finish the drawing..
● Click to draw the minimum size of the target, and click to draw the
maximum size of the target. Only when the target size between the maximum size
and the minimum size, can the alarm be triggered.
● Click , and then press and hold the left mouse button to draw a rectangle, the
pixel size is displayed.
● Click to delete the detection line.