User's Manual

User’s Manual
176
Setting ANPR 5.15
Extract information of motor vehicles and display related attributes on the live interface.
5.15.1 Scene Configuration
Configure non-motor vehicle detection.
Preparation
Select Setting > Event > Smart Plan, and then enable ANPR.
Procedure
Select Setting > Event > ANPR > Scene Set. Step 1
The Scene Set interface is displayed. See Figure 5-64.
Scene set (ANPR) Figure 5-64
Click Draw to draw a detect region and an exclude region in the image. Step 2
 Detect region: The region that needs to be detected.
 Exclude region: The region that does not need to be detected. Click Modify to
modify the drawn region.
Click Clear at the right side to draw the detection area again.
Click Draw Target next to Target Filter to draw the maximum size and minimum size Step 3
for the detection target in the image.
Configure parameters. See Table 5-21. Step 4