User manual
DocumentMT0100P.N
©XsensTechnologiesB.V. MTiandMTxUserManualandTechnicalDocumentation
53
TheMTiandMTxhardwaremustbekeptdryatalltimes.Condensemaydamagetheinternalelectronics.
The MTi and MTx hardware should be protected from electro static discharges or sources of radiation, as
exposuretosuchsourcewilldamagetheinternalelectronics.
The MTi and MTx hardware should be protected from violent handling such as drops on hard surfaces.
Excessiveshocksorviolenthandlingmaydamagethemotionsensors.
The MTi and MTx hardwareshould be protectedfrom strong vibrations. Excessiveand continuousvibration
maydamagethedevice.Pleasecontactsupport@xsens.com
formoredetailedinformation.
8.2 FCCspecificoperatinginstructions
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
whichcanbedeterminedby turningtheequipmentoffand on,theuserisencouragedto tryto correctthe
interferencebyoneormoreofthefollowingmeasures:
1. Reorientorrelocatethereceivingantenna
2. Increasetheseparationbetweentheequipmentandreceiver
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
4. Consultthedealeroranexperiencedradio/TVtechnicianforhelp
8.3 Safetyinstructions
CAUTION
• Readtheseinstructions
• DonotplacetheMTiorMTxnearstrongmagneticfields.
• Donotusecablesorconnectorsotherthandescribedinthismanual.