Technical information

ELECTRIC WIRE AND
TERMINALS KIT
Kit contains 12 feet of 16
gauge, up to 500 volts DC,
copper strand; (2) each 3/8”
16 gauge ring style terminals;
(2) each #8 16 gauge ring
style copper terminals; (2)
each female 14-16 gauge butt splice connectors;
(2) each 14-16 gauge female slip terminals; (2)
each 10-12 gauge female slip terminals.
PART NO. 79978
CYCLING SWITCH KIT
Heavy duty. Available in 6,
12, and 24 volt, 10 amp, 60-
120 cycles per minute (CPM),
Intermittent action, moisture
proof case.
PART NO. 79976 6V
79975 12V
79977 24V
THERMOSTATS
SURFACE MOUNT TYPE
Recommended to be
mounted on the flat surface
of the engine block. Circuit
operates at 50°F and below,
15 Amp, 12” of 14 gauge
wire lead(s). Internal
Ground (IG) style has only
one lead.
Packaged one (1) per pack.
PART NO. 78150 2 WIRE
79938 1 WIRE
78583 1/2"NPT
QUICK RELEASE
CLAMPS, CRADLES,
AND MOUNTING
HARDWARE KIT
Same heavy duty
quality. Fits Pull
Cable Series. Can
be used as a
Universal Cradle
and Clamp assembly. Quick Release clamps
are stainless steel and meets 35842 Mil-
standard. Includes two (2) cradles, two (2) quick
release clamps, and all nuts and bolts.
PART NO. 79964 CLAMP ONLY PART NO. 78596
ACTUATOR VALVE
ASSEMBLY WITH
MOUNTED CYCLING
SWITCH
Assembly includes
Cycling Switch and
Cycling Switch Socket.
12 or 24 Volt, 5-cc
metering chamber, 6-8
Amps, 8” of 16 gauge
wire leads, intermittent
duty, 65-120 cycles per minute (CPM),
straight valve fitting, gaskets, and protective
valve plug.
PART NO. 79974 (12 volt)
PART NO. 79993 (24 volt)
MOUNTING PLATE
AND QUICK RELEASE
CLAMPS
Fits all Automatic and
Push Button Series
units, dual cradles,
dual quick release
clamps, heavy duty
nuts, bolts, and
washers.
PART NO. 79968
COMPONENT PARTS AND ASSEMBLIES
THE FOLLOWING COMPONENTS, PARTS, AND ASSEMBLIES CAN BE
PURCHASED AS REPLACEMENT PARTS, OR AS STAND-ALONE
ASSEMBLIES IF SO REQUIRED. ORDER BY PART NUMBER.
ACTUATOR VALVE ASSEMBLY
Assembly includes 5-cc
metering chamber, 12 or 24
Volt, intermittent duty, 8”
of 16 gauge wire leads,
straight valve fitting,
gaskets, and protective
valve plug.
PART NO. 78615 (12 volt)
PART NO. 78590 (24 volt)
MANUAL ACTUATOR
VALVE ASSEMBLY
Includes mounting
bracket, pull lever, 5-cc
metering chamber,
straight valve fitting,
gaskets, and protective
valve plug.
PART NO. 78585
MOUNTING PLATE AND
CLAMPS
Fits all push button and
automatic Series units,
Super Heavy Duty Back
Plate dual clamps, dual
cradles, heavy duty
nuts, bolts and
washers.
PART NO. 79967
PUSH BUTTON SWITCH KIT
Single Pole - Single Throw
(SPST), 10 amp, momentary
ON, heavy duty.
PART NO. 78598
DASH LABEL ONLY
PART NO. 78597
63