Service manual

Panel Size 17-inch (43.2cm) diagonal
Pixel Pitch 0.264 x 0.264mm
Viewing Angle 75°(Right/Left)
70°(up), 70°(down)
Contrast Ratio 400:1 contrast ratio (typ)
Brightness 250cd/m
2
brightness (typ)
Color Filter RGB vertical stripe
Synchronization Horizontal 30 - 80KHz
Vertical 56 - 77Hz
Video Bandwidth 135MHz
Max Resolution 1280 x 1024 75Hz
Optimal Resolution 1280 x 1024 60Hz
Colors 8bit (16.7M Colors)
Display Area 337.9mm x 270.3mm
PC Input Signal Sync H/V separate (TTL)
Video 15 pin mini D-sub(Analog RGB)
DVI-D(Option)
AV Input Signal Video CVBS(RCA), S-Video(Mini-DIN)
(L700CAV only) Audio RCA Left+Right Input
Stereo Mini Jack Input & Output
TV Receiving Signal TV Tuner NTSC, PAL
(Option)
External Speaker Output 4W(Left 2W+Right 2W)
(L700CM/L701CM/L700CAV only)
Plug and Play VESA DDC Compatible
Power Source 100-240Vac, 50/60Hz (Free Voltage)
Power Consumption 45W (without speaker)
Dimension-W x H x D 420 x 398 x 194mm (with stand)
(without speaker) 420 x 360 x 68mm (without stand)
Weight-net/gross 6.2/7.6Kg(13.6/16.7lbs)
Power Saving EPA, VESA DPMS, Nutek Compliant
Tilt Range 5° forward, 30° backward
Operating Temperature 10 ~ 40°C /50 ~ 104°F
6
◆ Diode Removal/Replacement
1. Remove defective diode by clipping its leads as close as possible to diode body.
2. Bend the two remaining leads perpendicularly to the circuit board.
3. Observing diode polarity, wrap each lead out of the new diode around the corresponding lead on the
circuit board.
4. Securely crimp each connection and solder it.
5. Inspect the solder joints of the two “original” leads on the circuit board copper side. If they are not
shiny, reheat them and apply additional solder if necessary.
TECHNICAL INFORMATION
a
a
http://www.wjel.net