Technical data

Fitted Equipment
Powering with gas
Warning! - Flammable material must be
kept away from the refrigerator.
- For selection of gas type, see the
information plate inside your refrigerator.
- For the pressure regulator model, see the
information plate inside your refrigerator
and the table at the end of this booklet.
- The type of gas container and its location
must be in compliance with the most
recent regulations. Ensure that the unit is
installed in a location with good
ventilation and make sure that the
ventilation openings in the gas container
storage location remain open.
- The changing of the gas container must be
done outside in the open air and out of
reach of any possible sources of ignition.
- You are strongly advised not to use gas to
power the refrigerator while you are
driving. If a road accident results in fire,
there is a danger of explosion.
- You are strongly advised not to use gas to
power the refrigerator in the vicinity of
petrol stations.
1. Open the valve of the gas bottle and the
gas taps.
2. Set the Thermostat (B) to the highest level
(the biggest dot).
3. Set the energy source selector switch (A)
to:
4. Ignite the gas flame
Manual ignition (N90P)
- Press the thermostat (B), and keep it
depressed.
- Press the button for manual ignition several
times at intervals of between 1 and 2
seconds.
- Release the thermostat when the indicator
of the flame meter enters the green area. If
it does not enter the green area, repeat the
previous step.
Warning! Never keep the thermostat
depressed for longer than 30 seconds.
If a flame does not appear, wait at least
five minutes before trying again. If you
fail to observe this rule, there may be an
accumulation of gas creating the risk of
fire or explosion.
- Set the desired refrigeration level by means
of the thermostat (B).
(The bigger the dot, the colder the setting)
Electrical ignition (N90E):
- Press the thermostat (B) and keep it
depressed.
- Ignition takes place automatically. You will
hear a ticking noise. If ignition was
successful, the noise will stop and the
flame meter will turn green. Release the
thermostat.
- If the flame goes out, ignition will be
repeated automatically.
- Set the desired refrigeration level by means
of the thermostat (B).
(The bigger the dot, the colder the setting)
Switching off the refrigerator
- Set the energy source selector switch (A) to;
- The refrigerator is now completely switched
off.
- Use the door locking mechanism to lock
the open door. This prevents unpleasant
odours and mould in the refrigerator.
Important! If you are not going to use the
refrigerator for a prolonged period, close the
valve of the gas bottle and the gas taps.
91