Technical data

Fitted Equipment
90
- It is prohibited to use gas to power the
refrigerator in the vicinity of petrol
stations.
1. Open the valve of the gas bottle and the
gas taps.
2. Set the gas control button to the 5th
position.
3. Set the energy source selector switch (A)
to
4. Ignite the gas flame:
Manual ignition (N90P)
- Press the thermostat (B), and keep it
depressed.
- Press the button for manual ignition several
times at intervals of between 1 and 2
seconds.
- Release the thermostat when the indicator
of the flame meter enters the green area. If
it does not enter the green area, repeat the
previous step.
Warning! Never keep the thermostat
depressed for longer than 30 seconds. If
a flame does not appear, wait at least
five minutes before trying again. If you
fail to observe this rule, there may be an
accumulation of gas creating the risk of
fire or explosion.
- Set the desired refrigeration level by means
of the thermostat (B). (The bigger the dot,
the colder the setting)
Electrical ignition (N90E)
- Press the thermostat (B) and keep it
depressed.
- Ignition takes place automatically. You will
hear a ticking noise. If ignition was
successful, the noise will stop and the
flame meter will turn green. Release the
thermostat.
- If the flame goes out, ignition will be
repeated automatically.
- Set the desired refrigeration level by means
of the thermostat (B).
Switching off the refrigerator
- Set the energy source selector switch (A)
to;
- The refrigerator is now completely switched
off.
- Use the door locking mechanism to lock
the open door. This prevents unpleasant
odours and mould in the refrigerator.
Important! If you are not going to use the
refrigerator for a prolonged period, close the
valve of the gas bottle and the gas taps.
Electrical operation
The refrigerator can be powered by
electricity in two ways:
- DC (12V): Set the energy source selector
switch (A) to the refrigerator will now
be powered by the battery of your car or
camper.
Important! - Always use the gas connection
or mains voltage to start up the refrigerator
for the first time and to cool it. Powering
from the battery of your vehicle is suitable
only for maintaining the temperature of the
refrigerator and its contents once it has been
refrigerated.
- When powered by a vehicle battery the
refrigerator works without temperature
control (i.e. constant operation).
- Mains voltage (230 V): set the power
selector switch (A) to
- Set the temperature by means of the
thermostat, rotary switch (B).
(The bigger the dot, the colder the setting).
A = Energy source selector switch
B = Thermostat
C = Flame meter
D = Manual ignition (piezo electric ignition)