Technical data

Fitted Equipment
114
- Press the "MODE & SET" key to scroll
through the possible settings (manual fresh
air, manual warm air, ventilation,
automatic), select the required mode while
holding the key pressed down for two
seconds until the selected mode is
confirmed by the system.
Alarm visualisations
- When the display shows six horizontal
lines, the temperature probes are defective;
- When the display shows the ON symbol
and the timer symbol flashes, the system is
waiting that 2 minutes from the last
compressor stop elapse.
Mode Description Display visualisation
AUTOMATIC The +/- keys enables the user to change the PRE-SET TEMPERATURE.
In this mode, the machine automatically controls the compressor, the heater and the
ventilation speed by comparing the SET TEMPERATURE with the internal temperature.
MANUAL The +/- keys enables the user to change the PRE-SET TEMPERATURE.
FRESH AIR The +/- keys allows changing the VENTILATION SPEED.
In this mode, the machine automatically controls the compressor and compares the
SET TEMPERATURE with the internal temperature.
MANUAL The +/- keys enables the user to change the PRE-SET TEMPERATURE.
WARM AIR The +/- keys allows changing the VENTILATION SPEED.
In this mode, the machine automatically controls the heater and compares the
SET TEMPERATURE with the temperature inside the vehicle.
VENTILATION The +/- keys allows changing the VENTILATION SPEED.
The system only operates the fan inside the vehicle.
In this mode, compressor and heater do not run.