Service manual

12. To remove Rear heater assembly parts.

REF.NO PART CODE PART NAME DESCRIPTION

Q’ T

REMARK

1 7112401011 SCREW TAPPING T1 TRS 4X10 MFZN 1

2 3511407300 COVER MOTOR *B SBHG T0.6 1

3 7112401011 SCREW TAPPING T1 TRS 4X10 MFZN 2

4 3511407400 COVER *B SBHG T0.6 1

5 3512766900 HARNESS CONVECTION-B KOC-1B0K0S 1

6 3512803800 HEATER MIRACLON 115V 550W 270MM 2

7 3511407700 COVER HEATER *B SA1D T0.5 1

8 7113400814 SCREW TAPPING T1 BIN 4X8 MFNI 3

9 7400104011 WASHER PLAIN PW-1-4 MFNI 1

10 3511800700 FAN CONVECTION SA1D T0.5 1

11 7S627W50X1 NUT HEX NUT FLANGE M5X0.8P MFZN 1

12 3512766800 HARNESS CONVECTION-A KOC-1B0K0S 1

13 7601400811 SCREW MACHINE PAN 4X8 PW MFZN 2

14 3513302900 INSULATOR HEATER *B SA1D T0.5 1

15 7113400814 SCREW TAPPING T1 BIN 4X8 MFNI 4

16 3963514300 MOTOR SHADED POLE 230V 50Hz MW10CA-T02 1

17 3511800800 FAN PP GF20 1

18 7402704600 RING-C CR-5 SK5 1

(1) Remove a screw and then pull out Cover motor *b .

(2) Remove two screws and thenpull out Cover *b .

(3) Pull out the Harness convection-b .

(4) Remove four screws and then pull out the Rear heater assembly.

(5) Remove a Nut and then pull out the Fan convection and Washer plain .

(6) Remove three screws and then separate the Cover heater *b and the Insulator heater *b .

(7) Pull out two Heaters from the the Insulator heater *b .

(8) Remove two screws and then separate the Insulator heater *b and Motor shaded pole

(9) Remove the Ring-c and then pull out the Fan from Motor shaft.

(10) Reverse the above steps for reassembly.

11 10

8 7 6