Specifications

Power Train Testing and Adjusting

Installation of Pinion

1. Install cup of rear pinion bearing

2. Install spacer and shims on pinion (basic thickness

1.5mm (0.059 in)).

3. Install bearing cone.

4. Tap bearing cone to correct position(Rotate pinion

3-5 times)

5. Assemble yoke and nut and tighten flange nut to

180 ±15 N∙m (133±11 lb∙ft)

6. Measure the rolling torque. The value of rolling

torque should be 1.5~2.0 N∙m (1.1~1.5 lb∙ft)

7. If the rolling torque exceeds 2 N∙m, add one shim

and if it is lower than 1.5 N∙m, subtract one shim

8. When the adjustment is correct, disassemble the

nut and the yoke.

Assemble the oil seal and yoke again and then

tighten the nut to 180 ±15 N·m (133±11 lb·ft)