Operation Manual

E-26 E-27
E-26 E-27
Guide for other useful programs (cont.)
NOTE
• Do not use the detergent and softener.
• Cold water tap should be opened.
• After finishing this program,
is showed on PCB board alternately and the smoothing creases
program is conducted during 30 minute and then power is OFF.
• 'DELICATE', 'Quick 20', 'Tub Clean' and 'Drain' program are not selected with 'DRY'.
• Be careful the high temperature of laundry when put out clothes.
• A little shrikage and deformation will be possibly happened after drying, so check clothes whether dry or not
previously
• If the dry performance is poor, change the selecting temperature.
• If youn want to dry with wash, after selecting program, press the 'DRY' button then press 'Start/Pause' button.
1 Put the laundry into the Drum and close the Door.
2
Press the Power button.
• The LED shows only ‘ - --' signal.
3
Select the ‘ DRY CONDITION' you want by pressing ‘ DRY' button.
As this button is pressed, the dry condition is selected by
‘ Cupboard' → ‘ Very'
→ ‘ Time(1:00, 2:00, 3:00, 4:00)' → OFF → ‘ Low Temp' → ‘ Iron' → ‘ Cupboard'
4
Press the ‘ Start/Pause' button.
• The washer will be operated with locking Door.
* DRY (FOR DWC-LD1XXX , DWC-LU1XXX)