Specifications

6
At the end of every washing:
• Switch off the electricity of the power point.
• Check that both timers are set to the “O” position.
• Wipe off spillage (detergent powder,etc.), and generally wipe over the tub and base with a dry duster.
Cleaning after use will extend the life of your washing machine. Before cleaning disconnect the power
cord from the electrical outlet.
• Remove the overflow Filter by pulling it forward.
• Wash off the lint stuck on the overflow Filter during overflowing.
•
Re-install the overflow Filter: By first inserting its bottom section and then pushing the upper part firmly into place.
• Dirt maybe also collected underneath the pulsator.
• Clean out occasionally by remove the screw located in the
center of the pulsator.
• Hook the pulsator and pull upwards.
• Wash off the lint stuck on the bottom of the wash tub.
(When replacing the pulsator, make sure that the screw must be firmly tightened )
Overflow Filter
Pulsator
CLEANING AND MAINTENANCE
＊
• Use a screwdriver to loosen the screw of the pulsator, and remove the pulsator.
• Remove the drain strainer from the bottom of the tub using a sharp tool such as a driver.
• Wash off the lint stuck in the strainer.
• Re-install the drain strainer and pulsator.
Drain Strainer