DVD Recorder + VCR DVR-S04/DVR-S05 User Manual P/N : 97P95600N0-E0 Downloaded From Disc-Player.
Important Safeguards CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated ‘dangerous voltage‘ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
Important Safeguards Do not use this product near water. For example: near a bath tub, wash bowl, kitchen sink, laundry tub, in a wet basement; or near a swimming pool; and other areas located near water. 6 13 Unplug this product during lightning storms or 14 Clean only with dry cloth. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners. 7 Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Overview Overview Which discs you can use The following discs can be used in your DVD Recorder+VCR: DVD (Digital Versatile Disc) is a storage medium that combines the convenience of the compact disc with the latest digital video technology. DVD video uses modern MPEG2 data compression technology that enables an entire feature film to be stored on a single five inch disc.
Overview Remote Control Battery Installation Detach the battery cover on the rear of the remote control, and insert two AAA batteries. Make sure the polarities (+ and -) are aligned correctly. Recording TV Audio Channels The DVD Recorder+VCR can record one or two channel audio. For TV broadcasts, this usually means mono or stereo, but some programs are broadcast with a main and a SAP (Secondary Audio Program) audio channel. You can record either the main audio or the SAP audio.
Identification of Controls Identification of Controls INTRODUCTION Front Panel Front Panel Display ! @ # $ % ! @ ^ *) 2 & (1 3 45 # $ % ^ 1 REC SPEED Changes Record speed. 2 SELECT DVD/VCR Toggles control between the DVD deck and the VCR deck. Reset the DVD Recorder+VCR by pressing and holding it for 5 seconds. 3 Front Panel Display Shows the current status of the DVD Recorder+VCR. 4 CH+/– Scans up or down through memorized channels. Also moves up and down in DVD navigation menus.
Identification of Controls Identification of Controls INTRODUCTION Remote Control Turns the DVD Recorder+VCR on and off. - Opens and closes the disc tray in DVD mode. - Ejects the tape in the VCR deck in VCR mode. Selects DVD mode. - DVD: Searches backward/forward. - VCR: Rewinds/advances during Stop mode. Press during Play mode for fast reverse/forward picture search. Starts recording. Press repeatedly to set the recording time. For more details, Refer to One Touch Record (OTR) on page 39.
Identification of Controls Connections ! @# $% ^ OUT AUDIO OUT COMPONENT OUT R Pr R L Pb L • Make sure the DVD Recorder+VCR is connected directly to the TV, and the TV is set to the correct video input. • Do not connect the DVD Recorder+VCR’s AUDIO OUT jack to the phono in jack (record deck) of your audio system. • Do not connect the DVD Recorder+VCR via your VCR. The DVD image could be distorted by the copy protection system. ANT.
Connections Connections Connecting a TV Connecting an Amplifier/Receiver Choose one of the following TV connections, depending on the capabilities of your equipment. Connecting to an amplifier equipped with two channel analog stereo or Dolby Pro Logic ll/Pro Logic All video signals are available from all video outputs. That means that whichever TV connection you use, it will work with all input sources, including VHS out of the Component/Progressive Video Output.
Connections Initial Installation Connecting Optional Equipment Initial Installation To receive audio/video signals from other equipment, connect the LINE1 or LINE2 jacks on the DVD Recorder+VCR to the audio/video out jacks on your external component, using optional audio/video cables. After successfully connecting your DVD Recorder+VCR to your TV and other devices, this chapter will show you how to complete the initial installation.
Initial Installation 5 Select the desired disc playback subtitle language using […/†]. Press [ENTER] to confirm. Initial Setup Setup Menu Overview Installation Please select disc play back subtitle language: Default English Spanish French Italian Japanese Chinese Off Instructions The DVD Recorder+VCR Setup menu includes six categories, including: Installation, Recording Options, Languages, Preferences, System Info, and Restore Defaults.
Initial Setup Auto Channel Search The DVD Recorder+VCR has a frequency synthesized tuner capable of receiving up to 181 channels. These include VHF channels 2-13, UHF channels 14-69 and CATV channels 1-125. TV/CATV CATV Auto Channel Search Add/Remove Channels Modulator Out CH3 Set Clock Connect the DVD Recorder+VCR to the desired type of antenna or cable TV system, as shown in ‘Connecting Antenna/Cable‘ on page 11. 1 2 Follow steps 1-2 as shown under Tuning Band.
Initial Setup PREFERENCE / Video Settings Auto Chapter During recording, chapter markers are added automatically at fixed intervals. You can set this interval to 5 minutes, 10 minutes or 15 minutes. To turn off automatic chapter marking, select ‘Off‘. Follow the same procedure as the DVD Record Quality. Recording Options DVD Record Quality VCR Record Quality Auto Chapter HQ SLP Off Select Auto Chapter Off Enter-Confirm Setup-Exit Move …† Press [SETUP]. Use [œ/√] to select ‘Preference‘.
Initial Setup PREFERENCE / Audio Settings Virtual Surround Follow the same procedure as Video Settings to select Audio Settings. Preference Video Audio Parental Controls Auto Play Auto Clock VCR Instructions Digital Output 1 Use […/†] to select ‘Digital Output‘ while the Audio submenu is displayed. Audio Press [ENTER] to confirm your selection. Press [SETUP] to exit the menu. Instructions Press [ENTER] or [√] to go to the second level. Use […/†] to select the desired digital output type.
Initial Setup PREFERENCE / Parental Controls 8 Set Parental Level The Parental Controls feature allows you to prevent DVDs from being played based on their ratings or to have certain discs played with alternative scenes. You can set the parental level from 1 to 8. 1 2 3 Press [SETUP]. Use [œ/√] to select ‘Preference‘. While ‘Preference‘ is selected, press [†] to select ‘Parental Controls‘. Initial Setup Press [ENTER] to confirm your rating selection, then press [SETUP] to exit the menu.
Initial Setup Initial Setup Various PREFERENCE Settings System Information AutoPlay System Information helps service personnel identify key firmware information about your DVD Recorder+VCR in case service is required. With Auto Play turn ON (the factory default setting), the VCR automatically starts playback when you insert a tape with its safety tab removed. 1 2 3 4 Use […/†] to select ‘AutoPlay‘. Press [ENTER] or [√] to go to the second level. Use […/†] to set the AutoPlay Status.
On-Screen Display Overview On-Screen Display Overview The On-Screen Display provides feedback on the status of the DVD Recorder+VCR and/or the currently loaded disc or tape. To access the On-Screen Display (or OSD), press the [DISPLAY] button. Press [AUDIO] repeatedly to change the TV audio, according to the Broadcast audio signal as shown below.
On-Screen Display Overview Chapter Shows the current chapter number and total number of chapters, and skips to the desired chapter number. 1 2 3 4 Press [DISPLAY] during playback. The on-screen display appears on the TV screen. Use […†] to select the ‘Chapter‘ icon on the on-screen display. Press [ENTER] to display a submenu. Use […†] to change the numbers. Press [ENTER] to confirm. Angle Shows the current angle number and total number of angles, and changes the angle number.
DVD Playback DVD Playback Slow Motion A-B Press [SLOW+] to enter Slow Motion mode. The default speed is 1/2. When you press [SLOW+] repeatedly, the speed will be set to 1/4, 1/8, and normal speed. You can repeat a scene between two points (A and B): • Slow reverse playback is not supported. Changing the Audio Language Press [AUDIO] and then press [AUDIO] repeatedly during playback to hear a different audio language or audio track.
VCR Playback VCR Playback Before You Begin Special Playback Features Press the VCR button to set the remote control to operate the VCR deck. Turn the TV on and select the video input source connected to the DVD Recorder+VCR. Audio system: Turn the audio system on and select the input source connected to the DVD Recorder+VCR. Notes on special playback features Horizontal lines (noise bars) will appear on the TV screen. This is normal.
Other Disc Playback Other Disc Playback Audio CD/MP3 PLAYBACK The DVD Recorder+VCR can play audio CDs and MP3 files on CD-ROM, CD-R or CD-RW discs. 1 Insert the CD disc and close the tray. The Audio CD or MP3 CD menu appears on the TV screen after a few moments to load the disc. 2 Use […†] to select a track or a file, then press [PLAY] or [ENTER]. 3 4 5 Select the thumbnail you want to display using […†œ √] and press [ENTER].
Basic Recording Basic Recording Recording from TV One Touch Record (OTR) Follow the instructions below to record a TV program. One Touch Recording allows you add recording time in fixed increments at the touch of a button. 1 Turn on the DVD Recorder+VCR and load a recordable disc or tape. 1 Follow steps 1-4 under Recording from TV. 2 Press [REC (●)] repeatedly to set the length of the recording. Make sure your TV input is set to view the DVD Recorder+VCR.
Basic Recording One Touch Copy - DVD to VHS One Touch Copy - VHS to DVD • If the DVD you are attempting to copy is copy-protected, you will not be able to copy the disc. It is not permitted to copy Macrovision encoded DVDs. • Copy to VCR does not work in Progressive Scan Mode. 1 Insert a Disc. 2 Insert a DVD+R or DVD+RW disc. Insert a blank VHS videotape into the VCR deck. Insert a blank DVD+R or DVD+RW disc in the DVD deck and close the disc tray.
Timer Recording Timer Recording The Timer Recording function allows you to record up to 8 programs within a period of one month. Canceling a Timer Recording 1 Insert recordable media such as DVD+R ,DVD+RW, recordable VHS tape. 2 Press [TIMER]. You can clear a Timer Recording any time before the recording actually starts. • Use […†] to select the program you want to erase on the Timer Recorder List, then press [ENTER] to modify it. Use […†] to select 'Delete' then press [ENTER].
Recording from an External Input Recording from an External Input Recording from External Components Recording from a Digital Camcoder You can record from an external component, such as a camcorder or VCR, connected to any of the DVD Recorder+VCR’s external inputs. You can record from a digital camcorder connected to the DV IN jack on the front panel of the DVD Recorder+VCR. You can use the DVD Recorder+VCR remote to control both the camcorder and the DVD Recorder+VCR.
Editing Editing DISC Initialize 6 • If you load a blank DVD+R(+RW) disc, it will be initialized (formatted to enable recording). • Do not start recording until disc initialization is complete. • If you load a DVD+RW that has already been used you can record a program immediately. You can change the disc status by selecting ‘Yes‘ and pressing [ENTER]. Disc is unlocked.
Editing Title Menu Change Disc Name You can manage the titles on your DVD+R/RW discs using the Title menu. You can rename your disc to any name you choose. The default disc name is ‘MY DVD‘. 1 2 3 4 5 6 Use […] to go tothe top menu. Press [√] to display the Disc Information Menu. To play a title: Press [Enter] to change the disc name. 1 2 3 4 5 Press [ENTER] as shown on the screen. Instructions Enter-Confirm Use [œ √…†] to select and press [ENTER] to enter the name of the disc.
Editing Editing Change Name To change the name of a title: 1 2 3 Follow steps 1 to 3 under ‘Play Title‘. Select ‘Change Name’ using [œ √] . Editing Change Name … Press [ENTER] to change the title name. Press [Enter] to change the title name. When you insert a DVD+R or DVD+RW disc already recorded by your DVD Recorder+VCR, you can edit the titles and chapters in a variety of ways. To edit a recorded title, select the title on the disc menu and press [EDIT].
Editing Troubleshooting Check the following guide for the possible cause of a problem before contacting customer support. Hide Chapters This feature allows you to hide or unhide a chapter. After hiding a chapter, the chapter is not deleted but only hidden. If a chapter is hidden then it shows ‘Unhide Chapter‘ and vice versa. DVD Edit Title 1 of 2 Chapter 1 of 11 Edit Chapters Hide Chapter Change Index Picture Split Title Symptom Cause Solution No power. The power cord is disconnected. No picture.
Troubleshooting Symptom Cause Solution Camcorder image via A/V input to DVD Recorder+VCR is not shown on TV screen. Can’t play disc recorded on this DVD Recorder+VCR on another DVD player. DVD Recorder+VCR’s source is not set to LINE1/LINE2 composite. Use INPUT to select AV input channel (LINE1/LINE2 composite). 54 Downloaded From Disc-Player.com Daewoo Manuals Symptom Cause Solution The batteries in the remote control are dead. The remote control is locked. Replace the batteries.
Technical Specifications General Technical Specifications Outputs Power requirements Power consumption Dimensions (approx.) Mass (approx.) Operating temperature Operating humidity Signal system AC 120V, 60 Hz 34W 16.9 x 3.54 x 14.0 inches (430 x 91 x 354 mm) (w x h x d) 13.5 lbs (6.18 kg) 41°F to 95°F (5°C to 35°C) 5% to 90% NTSC Recording Recording formats Recordable discs Recordable time DVD Video Recording, DVD-VIDEO DVD+R, DVD+RW DVD ; Approx.
Warranty DEAM (Daewoo Electronics America) warrants each new electronic product manufactured by it to be free from defective material and workmanship and agrees to remedy any such defect or to furnish a new part (at the Company’s option) in exchange for any part of any unit of its manufacture which under normal installation, use and service disclosed such defect, provided the unit is delivered by the owner to us or to our authorized distributor from whom purchased or authorized service station intact, for o
