Specifications

AISIN AUTOMATIC TRANSAXLE 5A2 – 213
DAEWOO V–121 BL4
8. Install the pinion shaft so as to align the lock pin
holes on the pinion shaft and differential case.
9. Measure the side gear backlash while holding 1
pinion gear toward the case.
S Standard backlash:
0.05  0.20 mm (0.0020–0.0079 in.)
If the backlash is out of specification, install the
correct thrust washer to the side gear.
10. Referring to the table below, select thrust washers
which will ensure that the backlash is within the
specification.
Try to select washers of the same size for both
sides.
Thrust washer thickness : mm (in.)
Thickness Thickness
0.95 (0.0374) 1.10 (0.0433)
1.00 (0.0394) 1.15 (0.0453)
1.05 (0.0413) 1.20 (0.0472)
If the backlash is not within the specification,
install a thrust washer of a different thickness.
11. Using a hammer and punch, drive in the pin
through the case and hole in the pinion shaft.