Specifications

5A2 – 190IAISIN AUTOMATIC TRANSAXLE
DAEWOO V–121 BL4
11. Install the plate, 2 discs and 2 flanges.
S Install in order: F  D  P  D – F
(P = Plate, D = Disc, F = Flange)
12. Using a screwdriver, install the snap ring.
13. Check that the end gap of the snap ring is not
aligned with one of the cutouts.
WARNING : USE CAUTION WHEN CHECKING COM-
PONENTS WITH COMPRESSED AIR OR PERSONAL
INJURY MAY RESULT.
14. Install the forward and reverse clutch and thrust
needle roller bearing on the transaxle rear cover.
15. Using a dial indicator, measure the reverse clutch
pack clearance while applying and releasing 392
kPa (57 psi) of compressed air.
S Pack clearance: 0.40  1.00 mm (0.0157 
0.0394 in.) If the pack clearance is less than the
limit of pack clearance, parts may have been
assembled incorrectly, so check and reassemble
again.
If the pack clearance is non–standard, select
another flange.
There are 4 flanges in different thickness.
S Flange Thickness: mm (in.)
No Thickness No Thickness
1 3.0 (0.118) 3 3.4 (0.134)
2 3.2 (0.126) 4 3.6 (0.142)