Specifications

AISIN AUTOMATIC TRANSAXLE 5A2 – 173
DAEWOO V–121 BL4
7. Remove the direct clutch return spring.
8. Install the direct clutch on the oil pump.
WARNING : USE CAUTION WHEN REMOVING COM-
PONENTS WITH COMPRESSED AIR OR PERSONAL
INJURY MAY RESULT.
Notice : Blowing off the air may cause the piston’jump–
out.When removing the piston, hold it with your hand using
a waste cloth.
Notice : Take care not to splash ATF when air–blowing.
9. Apply 392 kPa (57 psi) of compressed air to the oil
pump to remove the direct clutch piston.
S When the piston can not be removed as it is
slanted, either blow the air again with the pro-
truding side pushed or remove the piston using
needle nose pliers with vinyl tape on the tip.
10. Using a small screwdriver, remove the O–ring from
the direct clutch piston.
11. Remove the O–ring from the input shaft.