Specifications

5A2 – 162IAISIN AUTOMATIC TRANSAXLE
DAEWOO V–121 BL4
114. Connect the manual valve control rod to the
manual valve lever as shown in the illustration.
115. Install the valve body assembly to the trans-
axle case.
Tighten
Tighten the bolts to 11 NSm (97 lb–in).
Notice : When installing the valve body to the transaxle
case, do not let each of accumulator pistons B1,C1,and
C2 incline. When installing the valve body to the transaxle
case, do not hold the solenoids.
116. Connect the transaxle wire connector and har-
ness to the valve body assembly.
117. Connect the 5 connectors.
a. Lock–up control solenoid
b. Pressure control solenoid.
c. No.2 shift solenoid.
d. No.1 shift solenoid.
e. Timing solenoid
118. Install the TFT sensor with clamp.
Notice : Make sure that the transaxle wire does not come
out from the oil pan installation surface.
119. Install a new gasket to the oil strainer.