Specifications

AISIN AUTOMATIC TRANSAXLE 5A2 – 155
DAEWOO V–121 BL4
81. Check to see if the sliding surface of the disc, plate
and flange of 2nd coast & O/D brake are worn or
burnt. If necessary, replace them.
Notice : If the lining of the disc is peeling off or discolored,
or even if a part of the printed mark is defaced, replace all
discs.
Notice : Before assembly new discs, soak them in ATF for
at least 15 minutes.
82. Using a screwdriver, install the snap ring to the
transaxle case.
Notice : Make sure that the snap ring is installed in the
groove of the transaxle case correctly.
83. Install the flange, 2 discs and 2 plates to the trans-
axle case.
S Install in order: P  D  P  D  F
(P = Plate, D = Disc, F = Flange)
84. Clean the connected part the transaxle case and
transaxle rear cover.
85. As shown in the illustration, place a straight edge
on the transaxle case and measure the distance
between the 2nd coast & O/D brake flange and
straight edge using vernier calipers. (Dimension A).