Specifications

8B–62 SUPPLEMENTAL INFLATABLE RESTRAINTS (SIR)
DAEWOO M-150 BL2
DTC 25 – Warning Lamp Failure (Cont’d)
Step Action Value(s) Yes No
11
1. Turn the ignition ON.
2. Using a multimeter, check the voltage at the fuse
F1.
Does the multimeter show the specified value?
11–14 v Go to Step 13 Go to Step 12
12
Repair the open power supply circuit for the fuse F1.
Is the repair complete?
–
Go to
Diagnostic
System Check
–
13
1. Disconnect the connector C208.
2. Turn the ignition ON.
3. Using a multimeter, check the voltage on the
instrument harness side of the terminal 3 of the
connector C208.
Does the multimeter show the specified value?
11–14 v Go to Step 15 Go to Step 14
14
1. Check the warning lamp bulb.
2. Replace the warning lamp bulb, if needed.
3. If the bulb is good, repair the open circuit between
the fuse F1 and the terminal 3 of the connector
C208.
Is the repair complete?
–
Go to
Diagnostic
System Check
–
15
1. Disconnect the negative battery terminal.
2. Wait at least 1 minute before proceeding.
3. Replace the SIR wiring harness.
Is the repair complete?
– System OK –