Specifications

SUPPLEMENTAL INFLATABLE RESTRAINTS (SIR) 8B – 39
DAEWOO M-150 BL2
DTC 13 – Passenger Pretensioner Circuit, Resistance Too High
Step Action Value(s) Yes No
1
1. Disconnect the negative battery cable.
2. Wait 1 minute for the SDM capacitor to discharge.
3. Examine the wiring and the connector at the
passenger seat belt pretensioner module.
Is the connector disconnected?
– Go to Step 2 Go to Step 3
2
1. Reconnect the passenger seat belt pretensioner
module connector.
2. Reconnect the negative battery cable.
Is the repair complete?
–
Go to
Diagnostic
System Check
–
3
1. Disconnect the electrical connector for the
passenger seat belt pretensioner module.
2. Disconnect the electrical connector at the SDM.
D The shorting bar at the disconnected SDM
connector will create a complete circuit be-
tween the wires from the passenger seat belt
pretensioner module.
3. Connect an ohmmeter to the terminals on the
SDM side of the wiring harness connector for the
passenger seat belt pretensioner module.
D Refer to ‘‘Diagnostic Illustration 19’’ in this
section.
Does the ohmmeter show the specified value?
≈ 0 W Go to Step 4 Go to Step 6
4
1. Replace the SDM.
2. Reconnect the negative battery cable.
3. Set the scan tool for CODE ERASE.
4. Do the diagnostic system check.
Does the code 13 still show as a current fault?
– Go to Step 5 System OK
5
1. Replace the passenger seat belt pretensioner
module.
2. Reconnect the negative battery cable.
Is the repair complete?
–
Go to
Diagnostic
System Check
–
6
1. Replace the supplemental inflatable restraints
(SIR) wiring harness.
2. Reconnect the negative battery cable.
Is the repair complete?
–
Go to
Diagnostic
System Check
–