Specifications

SUPPLEMENTAL INFLATABLE RESTRAINTS (SIR) 8B – 33
DAEWOO M-150 BL2
DTC 10 – Driver Pretensioner Circuit, Resistance Too Low
Step Action Value(s) Yes No
1
1. Disconnect the negative battery cable.
2. Connect an ohmmeter to the terminals of the
wiring harness connector for the driver seat belt
pretensioner module on the SDM side of the
connector.
D Refer to ‘‘Diagnostic Illustration 16’’ in this
section.
Does the ohmmeter show the specified value?
∞
Go to Step 2 Go to Step 4
2
1. Replace the SDM.
2. Reconnect the negative battery cable.
3. Set the scan tool to CODE ERASE.
4. Do the diagnostic system check.
Does the code 10 still show as a current fault?
– Go to Step 3 System OK
3
1. Replace the driver seat belt pretensioner module.
2. Reconnect the negative battery cable.
Is the repair complete?
–
Go to
Diagnostic
System Check
–
4
1. Replace the supplemental inflatable restraints
(SIR) wiring harness.
2. Reconnect the negative battery cable.
Is the repair complete?
–
Go to
Diagnostic
System Check
–