Operation Manual

by using the OSD instructions on the buttom Of the
screen When you have finished, , press ɼ/ɽ
9
Menu Operation
NOTE: When you initially use the TV, you will see the “First Time Installation” menu as below:
You can select “Country” and “Language”(OSD
display laguage), and select the contents of the
Auto Search(Analogue Program or Digital Program)
(PR+/-)button to select “OK”, and press button to
start auto
search.
The TV will start searching from the lowest
frequency(You can press SYS MENU to cancel
the auto search.). When it finds a station, it will
automatically store this in the first location and
move to the next. When Autosearch is complete,
the TV will display the first station found.
If you want to change the order of the programs, you could use the "Program Edit" function to change(see
page 15).
1. Press VOL+/- to adjust the volume.
2. If you want to switch the sound OFF, press the
MUTE button.
3. You can cancel this function by pressing MUTE or VOL+ button.
Basic TV operation
First time installation
First Time Installation
Country
Language
Delete Analog Program
Analog Program Search
Delete Digital Program
Digital Program Search
UK
English
OK
Cancel
Select
Adjust
1. Using the PR+/PR- on the front panel or on the remote control.
Press PR+ to increase channel number.
Press PR - to decrease channel number.
2. Using 0-9 digital buttons and -/-- button
Press -/-- button, then the screen will display “-”, press again it will become “- -”.
When it displays “-”, you should then press a number of 0-9 to watch the channel you desire;
When it displays “- -”, you should then press two numbers to watch the channel you desire.
TURN ON THE LCD TV
1. Connecting to the power with the mains adaptor and mains cable, at this time the TV will enter standby
mode and indicator shows red.
2. Use POWER button on TV set or on the remote control to turn on the LCD TV from standby mode.
TURN OFF LCD TV
Press the POWER button on the TV set or on the remote control to enter standby mode. The Indicator goes red.