Specifications

70
* DSB-240LH
PROCEDURES PHOTOS
1.Stop the air conditioner and dis connect the wire from in door unit to out
door unit.
2. Disassemble the case. (Fig 1~2)
1 Remove the Top Panel. (Loosen two screw and remove six hook)
2Remove the Front Cabinet. (Loosen four screw and four hook)
3Remove the Side Cabinet and Back Cabinet. (Loosen eight screw)
3. Removing the Propeller Fan. (Fig 3)
1Loosen the screw for fixing the motor bracket.
2Remove the Plain Washer.
3Remove the Propeller Fan.
4. Temove the panel control. (Fig 4)
1Disconnect the wire at control panel.
2Loosen a screw at panel control.
3Remove the parts on panel control.
5. Remove the partition panel. (Fig 5)
1Loosen four screws at bracket motor.
2Disconnect the wire at control panel.
6. Removing the Over load Protector. (Fig 6)
1Remove the cocondenser
2Loosen three volts at compressor.
3Remove the compressor.
Fig 1
Fig 2
Fig 3
Fig 5
Fig 4
Fig 6