Specifications

4-16 Remote Programming
DS360 Ultra Low Distortion Function Generator
Status Reporting Commands
Note: See tables at the end of the programming section for Status Byte definitions.
*CLS
The *CLS common command clears all status registers. This command does not
affect the status registers.
*ESE (?) i
The *ESE command sets the standard event status byte enable register to
decimal value i.
*ESR? {i}
The *ESR common command reads the value of the Standard Event Status
Register. If the parameter i is present, the value of bit i is returned (0 or 1).
Reading this register will clear it, while reading bit i will clear just bit i.
*PSC (?) i
The *PSC common command sets the value of the power-on status clear bit. If
i=1, the power-on status clear bit is set and all status registers and enabled
registers are cleared at power on. If i=0, the bit is cleared and the registers
maintain their values at power on.
*SRE (?) i
The *SRE common command sets the serial poll enable register to the decimal
value of parameter i.
*STB? {i}
The *STB common query reads the value of the serial poll byte. If i is present,
the value of bit i is returned (0 or 1). Reading this register has no effect on its
value as it is a summary of other status registers.
DENA (?) i
The DENA command sets the status enable register to the decimal value of
parameter i.
STAT? {i}
The STAT? query reads the value of the DDS status byte. If i is present, the
value of bit i is returned (0 or 1). Reading this register will clear it while reading
bit i will clear just bit i.