Specifications

3-18 Operation

DS360 Ultra Low Distortion Function Generator

Instrument Setup

This section describes the DS360’s default settings, storing and recalling settings, setting the computer

interfaces and running the self-tests.

Default Settings

Press [RCL][0] to recall the DS360’s default settings. This is a good place to begin

whenever you wish to start the instrument from a known state. The default settings are

listed below. See Chapter 5 for information on the default settings for the digital output.

Default Settings

Setting Default Value

Function Sine

Frequency 1.00000 kHz

Amplitude 1.000 Vrms

Offset 0.00 V

Output On/Off On

Output Type Unbalanced

Output Mode Analog

Output Impedance Hi-Z

Modify Function Linear Sweep

Modify Function On/Off Off

Start Frequency 1.000 Hz

Stop Frequency 100.000 kHz

Sweep Rate 1.0 kHz

Trigger Source Internal

Burst Depth 50%

Burst Count 1

Burst Rate 10

2-Tone Tone 1 Frequency 1.00000 kHz

2-Tone Tone 2 Frequency 10.0000 kHz

2-Tone Tone 1 Amplitude 1 Vrms

2-Tone Tone2 Amplitude 1 Vrms

2-Tone Mode Sine-Sine

Bandwidth Limited Noise Center Frequency 0 Hz

Bandwidth Limited Noise Bandwidth 3.2 kHz

GPIB Address As set

RS-232 Baud Rate As set

Storing and Recalling Settings

Storing Settings

The DS360 can store up to 9 independent instrument setups in non-volatile RAM,

separate from the default settings ([RCL][0]). To store the current instrument setup, press

[STO] followed by a location number (1-9). After any of the units keys are pressed, the