Specifications

Operation 3-17
DS360 Ultra Low Distortion Function Generator
Center Frequency
The center frequency can vary from 0 Hz to 200.000 kHz in 200 Hz increments. To
display the current center frequency, press the [CENTER] key. To change the center
frequency, type a new value using the numeric keypad, followed by the appropriate units
(Hz or kHz). If an out of range frequency is entered, the DS360 will beep, display “Freq
Err” and flash the ERR LED.
For bandwidth limited noise with high center frequencies and/or wide bandwidths there
can potentially be a reduction in noise power. When
CENTER FREQUENCY + 1/2 BANDWIDTH > 200 kHz
the amplitude will be slightly reduced. This is due to the fact that the white noise
generator has a bandwidth of 200 kHz, so any part of the noise bandwidth above 200 kHz
will be filtered.