Specifications

Operation 3-1
DS360 Ultra Low Distortion Function Generator
Chapter 3
Operation
The following sections describe the operation of the DS360. The first section describes the basics of
setting a function, including setting the function type, amplitude, frequency and offset. The second
section explains setting the output configuration, including the output type and source impedance. The
third section explains sweeps, bursts and bandwidth limited noise. The final section explains storing and
recalling setups, running self tests and setting up the computer interfaces.
In this Chapter
Power On 3-3
Caution 3-3
Reset 3-3
Setting Functions 3-4
Function Type 3-4
Frequency 3-4
Amplitude 3-5
Unbalanced Amplitude Ranges 3-6
Balanced Amplitude Ranges 3-7
Offset 3-8
Function On/Off 3-8
Output Configuration
3-9
Output Type 3-9
Source Impedance 3-10
Modify Function 3-11
Modify Function Type 3-11
Modify Function On/Off 3-11
Modify Function Parameters 3-11
Sweeps 3-11
Bursts 3-13
Bandwidth Limited Noise 3-16
Instrument Setup 3-18
Default Settings 3-18
Storing and Recalling Settings 3-18
GPIB Setup 3-19
SRQ 3-19
RS-232 Setup 3-19
Self Tests 3-20