Owner`s manual

Connections and Assembling

To the TV via antenna cable (if you are not using a RCA cable)

■ If you are using a RCA cable, select the AV input on the TV to see the picture from the player.

■ If you are not using a RCA cable, select the button number on the TV reserved for video input to see the picture

from the player.

If you are not using a RCA cable, your player can transmit pictures and sound to the TV via the coax aerial cable. Just tune the

TV to the player's transmitting channel (factory set to UHF CH 52). Tune the TV carefully to ensure the best pictures and

sound.

Once you have carried out the steps in "Connecting up the player", switch on your

TV.

Press the [OK] button of the player’s remote control longer than 5 seconds to call

the player´s test picture.

Tune the TV to the test picture using the channel pre-set functions of your TV as

described in its manual.

When you have found the test picture, store it under the button number on your TV

for player input.

Press the [OK] button of the player’s remote control again longer than 5 seconds to

release the test picture.

• If the quality of the test picture transmitted to the TV is poor due to interference

caused by a station transmitting on channel 52, you can tune the player to a

different transmitting channel. Find a free channel between 21 and 69 on your TV.

Call the player’s "SETUP" choose "VCR SETUP" then "RF OUTPUT SET".

Type in the free channel.

Store and exit.

• If the quality of the test picture transmitted to the TV is poor, fine-tuning on the TV may help (refer to the

TV manual).

• Without a RCA cable, you will not get stereo sound from a TV capable of stereo sound.

RF OUTPUT SET

0-9:SELECT (21-69)

œ/√:SELECT (BG/DK)

OK:CONFIRM SETUP:END

CH 52

SYSTEM BG DK

ASSEMBLING

Should you wish to assemble your own film, from camcorder footage for example, use the assembly technique for smooth edit

points:

• Move the tape to the position at which the new scene is to be added using the play functions.

• Wind back slightly before the edit point and put the machine into pause using the [PLAY/PAUSE]

button (do not press STOP!).

• Now go directly into record.

For the best results, the source cassette from which you are recording should already be playing back

when you start recording.

Downloaded from www.Manualslib.com manuals search engine

Downloaded From Disc-Player.com Daewoo Manuals