Specifications

61
24. Turn the tensioning pulley to the left until
the pointer is aligned with the notch.
(igs. 6/7)
25. Tighten the tensioning pulley nut, tighten-
ing torque: 27 Nm.
26. Remove the locking pin.
27. Turn the engine drive two more times,
check the setting and adjust if necessary.
28. Screw in the cylinder block plug.
29. Insert new plugs at the end of the
camshaft.
30. Install the components in reverse order of
removal. Fill up the cooling water and vent
the cooling system.
31. Record the replacement of the original
ContiTech timing belt on the supplied
sticker and aix it in the engine compart-
ment.
32. Test run the engine or take a test drive.
Fig. 7
Fig 6
ContiTech Technical Info / Installation Tips