Specifications

58
Installation:
1. Check whether the locking pin is inserted.
The crankshaft must be up against the
locking pin.
2. The grooves in the camshafts must be
aligned.
3. Also check whether the alignment ruler is
correctly applied.
4. Then install the new water pump.
Note: Carefully clean the sealing surface
between engine block and water pump
and remove any remaining seal.
5. Install the new guide pulley and tighten
to 45 Nm. (ig. 2)
Note: Pay attention to the tightness of the
bolt that holds the tensioning pulley in the
water pump housing.
6. Install the new tensioning pulley and
tighten the nut to 7 Nm for the time being.
(ig. 3)
Fig 3
Fig. 2
Fig. 1
ContiTech Technical Info / Installation Tips