User`s manual

7
CH2. START TO INSTALL
CH2. Start to install
1. Check the voltage switch
Please check which voltage will be supported to the system. The defa u l t
setting of the voltage switch is 230V, but if 115V will be used in the
s y s t e m, change the voltage switch, which is located at the back of the
t o w e r, to 115V.
Do not connect power cables to the system until you finish all the described installateion.
2. Connecting the keyboard and the mouse
◎ Check the key b o a rd connector which is located at the back of the
t o w e r. ( )
◎ Check the mouse connector which is located at the back of the tower.
( )(Refer to the picture )
▲ default mode : 230V ▲ other mode : 115V