User guide

AutoEnginuity ScanTool User Guide 37
will be given the chance to select the filename and path where the
data logging will occur. Make sure that you have enough space
available on the drive you select; data logging doesn’t take much
memory, but it will add up if you record multiple sensors for long
periods of time. Once the output filename is set, data logging will
begin.
When data logging is in the recording state, a checkmark will
be placed next to the Record menu item to signify that recording is
active. At the bottom of the main window, the Data Logging status
will read Recording and the LED will illuminate bright red. The
Data Logging File will reflect the output filename and path that you
set earlier. You can now add and remove sensors from either the
Live Data Meter, Live Data Graph, O2 Sensors, or the Dashtop. To
help you keep track of any faults that the connected vehicle might
have, Diagnostic Trouble Codes are also recorded while in the
Recording mode.
If the connection to the vehicle is lost, the data logging is
stopped and the file is closed as if Stop had been selected from the
Data Logging menu.
Stop