Service manual

Standard Check point

1. Power source : 100 - 240Vac, 50/60Hz.

2. Aging : Take at least 20 minutes warm-up time.

3. Signal

• Video input : Analog 0.7Vpp 75Ω terminal positive polarity

• Synchronizing : acceptable negative or positive at TTL level

• Max. Resolution :

15”-1024 x 768@75Hz

• Frequency:

15”-Horizontal : 30KHz - 62KHz

Vertical : 50Hz - 75Hz (available only non interlace mode)

Adjustment

1. Sharpness set to 0%

2. Contrast set to 100%

3. Brightness set to 100%

4. Switching to factory alignment mode

Press power key with Brightness left key at the power off status.

5. Set up the tracking

See the SVC manual at page 14th.

6. Switching to user’s mode

If turn-off and turn-on then switched to user’s mode.

All of adjusted data stores by fade out of OSD.

ALIGNMENT PROCEDURE