Service manual

6
◆ Diode Removal/Replacement
1. Remove defective diode by clipping its leads as close as possible to diode body.
2. Bend the two remaining leads perpendicularly to the circuit board.
3. Observing diode polarity, wrap each lead out of the new diode around the corresponding lead on the
circuit board.
4. Securely crimp each connection and solder it.
5. Inspect the solder joints of the two “original” leads on the circuit board copper side. If they are not
shiny, reheat them and apply additional solder if necessary.
TECHNICAL INFORMATION
Panel Size 15.1-inch (38cm) diagonol
Pixel Pitch 0.3 x 0.3 mm
Synchronization Horizontal 30 - 62 KHz
Vertical 50 - 85 Hz
Plug and Play DDC1/2B/CI
Power Saving EPA, VESA DPMS, Nutek Compliant
Power Source 100-240 Vac, 50/60Hz (Free Voltage)
DC12V, 3A
Power Consumption 21W(without adapter)/26W(with adapter)
Dimension-W x H x D(net/gross) 390 x 401.5 x 73.5mm /502 x 502 x 242mm
Weight(net/gross ) 4.5/6.4 Kg
9.9/14.1lbs
Tilt/Swivel Range Tilt 5° forward, 30° backward
Swivel ± 90° leftward, rightward
Operating Temperature 10 ~ 40°C /50 ~ 104°F